Office Building BMS Integration & DDC Control
Scenario. A commercial office building runs a chiller plant, AHUs, fresh-air units and tenant sub-metering. The building management system must present all of it through one interface.
The challenge
- Equipment had accumulated across phases of fit-out, with a mix of BACnet and Modbus devices.
- Tenant areas needed separate monitoring without separate systems.
- Engineering staff needed to adjust control strategies without a specialist contractor on site.
How the system is built
- Field control: MVC-WMB-1866BA controllers run DDC sequences for AHUs and fresh-air units, with 12 analogue inputs, 12 digital inputs and 6 digital outputs and non-volatile 3 V FLASH storage.
- Engineering tooling: MatyVisual configures I/O, writes and simulates DDC programs, generates point schedules automatically and downloads them over BACtalk – so strategies can be adjusted on site.
- Integration: MatyLink QSP-400B gateways convert Modbus RTU to BACnet/IP or BACnet MS/TP, and MatyContrE provides the browser-based management view with 3D graphics for plant and floor layouts.
Why it works
Standardising on BACnet at the supervisory level while converting at the gateway means phases of legacy equipment stay in service, and the engineering toolchain keeps routine strategy changes in-house.
Products used
MVC-WMB-1866BA field controller · MatyVisual DDC software · MatyLink QSP-400B gateway · MatyContrE building automation software