Data Centre Liquid Cooling Loop Monitoring & Control
Scenario. High-density AI racks have pushed rack power into the hundreds of kilowatts, beyond what air cooling can remove. Cooling is moving to liquid loops with cold plates, manifolds and cooling distribution units (CDUs), and the control system has to hold coolant temperature stable.
The challenge
- Coolant supply temperature must stay within a narrow band – drift forces chip throttling.
- Pumps starting and stopping frequently wastes energy and shortens equipment life.
- Sensors, controllers and gateways often come from different vendors with different protocols, so data never reaches one monitoring platform.
How the system is built
- Control layer: P-IOM633 programmable I/O modules run PID control on CDU secondary-loop coolant temperature, fan and pump speed, with firmware customised to the site's primary/secondary loop coordination. Parameters are tuned through the built-in web interface at http://192.168.5.2/.
- Sensing layer: EE65 air velocity transmitters monitor air-side airflow, Dwyer MS differential pressure transmitters watch filter and loop pressure drop, HUBA pressure transmitters cover hydraulic pressure, and ZB-TnRH transmitters report room temperature and humidity against ASHRAE guidance of 20–25 °C and 40–60% RH.
- Gateway layer: MatyLink DSP gateways convert between BACnet/IP, BACnet MS/TP and Modbus RTU, and MQTT conversion carries the data to a cloud or DCIM platform.
- Integration layer: the whole installation is presented to the customer's BMS/DCS through BACnet.
Why it works
PID control on the coolant loop keeps supply temperature steady and avoids pump cycling, while protocol conversion means cooling data joins the rest of the facility monitoring instead of sitting in a separate system.
Products used
P-IOM633 programmable I/O module · EE65 air velocity transmitter · Dwyer MS differential pressure transmitter · HUBA pressure transmitter · ZB-TnRH temperature & humidity transmitter · MatyLink DSP gateway